Plinko Board Diy

Plinko is a game where players drop a token or puck down a pegboard and it bounces off the pegs until it lands in one of the slots at the bottom. The slots are worth different points, and the player with the most points at the end of the game wins.

To make a Plinko board DIY, you will need:

• A piece of plywood or MDF
• 1/4" dowels
• Wood glue
• Paint or stain
• Drill
• Saw
• Sandpaper

Instructions:

1. Cut the plywood or MDF to your desired size.
2. Mark the locations of the dowel holes on the plywood. The holes should be spaced evenly apart, and there should be at least 2 inches between each hole.
3. Drill holes at the marked locations.
4. Cut the dowels to size. The dowels should be long enough to fit through the holes and protrude from the back of the plywood by about 1/4 inch.
5. Glue the dowels into the holes.
6. Allow the glue to dry completely.
7. Paint or stain the Plinko board.
8. Add a frame to the Plinko board, if desired.
9. Cut slots into the bottom of the Plinko board. The slots should be wide enough to fit the tokens or pucks.

To play Plinko, simply drop a token or puck down the pegboard and watch it bounce off the pegs until it lands in one of the slots. The player with the most points at the end of the game wins.

Tips:

• For a more challenging game, use smaller slots and fewer pegs.
• You can make your Plinko board more decorative by painting the dowels different colors or by adding artwork to the plywood.
• If you are using a large Plinko board, you may want to add legs to it for support.