Diy Shower Remodel

DIY shower remodel involves removing the old shower, installing a new shower pan, cement board, and tile, and then grouting and sealing the tiles. It is a challenging project, but it can be done with careful planning and execution.

Here are the basic steps:

Remove the old shower. This includes the shower curtain or door, the tile, the cement board, and the shower pan. Be careful not to damage the plumbing or wiring behind the walls.
Install the new shower pan. Make sure the pan is level and that the drain is properly installed.
Install the cement board. Cut the cement board to fit the walls of the shower and screw it into the studs.
Tile the shower walls. Start at the bottom of the wall and work your way up. Use spacers to ensure that the tiles are evenly spaced.
Grout the shower tiles. Mix the grout according to the manufacturer’s instructions and apply it to the tiles with a grout float. Wipe away any excess grout with a damp sponge.
Seal the shower tiles. Apply a sealant to the tiles to protect them from water and stains.

Once the sealant has dried, your new DIY shower remodel is complete!